Impala V6-3.8L VIN K (2004)
2. Position the engine support table with the frame under the vehicle.
3. Lower the vehicle to the frame.
4. Loosely install the bolts to secure the rear frame to the body.
5. Loosely install the bolts to secure the front and rear frame to the body.
Notice: Refer to Fastener Notice in Service Precautions.
6. Align the frame to the body by inserting two 19X203 mm (0.74X8.0 in) pins in the alignment holes on the right side of the frame.
*
Tighten the new front frame bolts to 160 N.m (118 lb ft).
*
Tighten the new rear frame bolts to 165 N.m (122 lb ft).
7. Connect both the lower ball joints to the steering knuckle.
8. Install the nuts which secure the engine mount to the frame.
*
Engine Mount Replacement in Engine - 3.4L
*
Engine Mount and Bracket Replacement in Engine - 3.8L
9. Install the nuts which secure the transaxle mount to the frame.
10. Remove the power steering gear from the exhaust pipe. Position to the frame.
11. Install the steering gear mounting bolts.
12. Install the stabilizer shaft links.
