Impala V6-3.8L VIN K (2004)
Notice: The knuckle must be retained after the strut-to-knuckle bolts have been removed. Failure to observe this may cause ball joint and/or wheel
drive shaft damage.
7. Remove the strut to knuckle bolts.
8. Remove the strut from the vehicle.
Installation Procedure
Notice: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause
premature failure.
1. Install the strut into place.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the strut to knuckle bolts.
^
Tighten the strut to knuckle bolts and nuts to 120 Nm (89 ft. lbs.).
