Impala V6-3.8L VIN K (2004)
Notice: Refer to Fastener Notice in Service Precations.
2. Install the transaxle mount lower nuts to the frame.
Tighten the transaxle mount lower nuts to 63 Nm (46 ft. lbs.).
3. Lower the transaxle so the transaxle mount studs install into the transaxle bracket.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the transaxle mount upper nuts to the transaxle mount.
Tighten the transaxle mount upper nuts to 47 Nm (35 ft. lbs.).
5. Remove the transmission jack from the transaxle.
6. Install left inner splash shield.
7. Install the left wheel and tire assembly.
8. Lower the vehicle.
