Impala V6-3.9L (2007)
Rear Door Panel: Service and Repair
Rear Side Door Water Deflector Replacement
Rear Side Door Water Deflector Replacement
Removal Procedure
1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Impala) .
2. Remove the rear door pull handle bracket from the rear door inner panel.
3. Disconnect all of the required electrical connectors.
4. Remove the inside door handle gasket.
5. Remove the rear door water deflector from the rear door inner panel.
Installation Procedure
1. Align the rear door water deflector to the rear door inner panel. Secure the water deflector at the corners.
2. Pull the rear door wiring harness leads through the slits in the rear door water deflector.
3. Install the rear door water deflector, start pressing the adhesive pattern at the bottom center and working outward and upward in order to prevent
puckering.
4. Install the inside door handle gasket.
5. Connect all of the required electrical connectors.
6. Install the rear door pull handle bracket to the rear door inner panel.
7. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Impala) .
