Impala V6-3.9L (2007)
1. Assemble the actuator (4) to the park brake shoe.
2. Install the park brake shoe and actuator (4) onto the backing plate (7).
3. Position the park brake shoe, actuator (4), and backing plate (7) over the rear hub.
Notice: Refer to Fastener Notice.
4. Install the park brake cable bracket (8) and the two retainers (9)
Tighten the bracket retainers to 14 N.m (124 lb in).
5. Install the rear hub.
The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.
6. Install and connect the rear park brake cable to the bracket at the rear wheel.
7. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
8. Install the rear rotor.
9. Install the rear caliper bracket.
10. Install the rear tire and wheel assemblies.
11. Adjust the park brake system.
12. Lower the vehicle.
