Impala V6-3.9L (2007)
Spot Lamp: Service and Repair
Spot Lamp Replacement (Impala RPO 7X6, 7X7)
Spot Lamp Replacement (Impala RPO 7X6, 7X7)
Removal Procedure
1. Remove the spot lamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
2. Disconnect the electrical connector.
3. Remove the spot lamp handle wedge key screw from the spot lamp handle.
Loosen the wedge key screw a few turns then with a light tap with a suitable hammer to the wedge key screw will loosen it from the spot lamp
outer tube shaft.
4. Remove the spot lamp handle from the outer tube shaft.
5. Remove the rubber grommet from the outer tube shaft.
6. Loosen the spot lamp bracket set screw.
7. Pull the spot lamp with the outer tube shaft out of the spot lamp mounting bracket and set aside.
8. Remove the spot lamp mounting bracket screws.
9. Remove the mounting bracket and the gasket from the windshield pillar.
10. Clean the mounting surface of the windshield pillar.
Installation Procedure
Important: This method of installation will stop the chance of any alignment and binding problems.
