Impala V6-3.9L (2007)
Stabilizer Bushing: Service and Repair
Rear Suspension
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the bolt from the stabilizer shaft insulator bracket (3).
3. Remove the stabilizer shaft insulator bracket.
4. Remove the stabilizer shaft insulator (2) from the stabilizer shaft.
Installation Procedure
1. Install the stabilizer shaft insulator (2) to the stabilizer shaft.
2. Install the stabilizer shaft insulator bracket (3).
Notice: Refer to Fastener Notice.
3. Install the stabilizer shaft bracket nuts.
Tighten the bolts to 48 N.m (35 lb ft).
4. Lower the vehicle.