Impala V6-3.9L (2007)
Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these
fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
Notice: Refer to Fastener Notice.
2. Install NEW wheel bearing/hub bolts.
Tighten the NEW wheel bearing/hub bolts to 130 N.m (96 lb ft).
3. Install the brake rotor and caliper.
4. Install the front wheel drive shaft nut. Insert a drift on a flat bladed tool into caliper and rotor to prevent the rotor from turning.
Tighten the front wheel drive shaft nut to 190 N.m (140 lb ft).
Important: Ensure that the connector clip engages the bracket properly.
5. Install the wheel speed sensor electrical connector to the bracket, if equipped.
6. Connect the wheel speed sensor electrical connector (2), if equipped.
7. Install the tire and wheel.
8. Lower the vehicle.
