Impala V6-3.9L (2007)
Wheel Bearing: Service and Repair
Rear Suspension
Wheel Bearing/Hub Replacement - Rear
Removal Procedure
Important: The wheel bearing in the rear wheel hub is integrated into one unit. The hub is non-serviceable. If the hub and/or bearing is
damaged, replace the complete hub and bearing assembly.
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tires and wheels.
3. Remove the brake rotor.
Rear Wheel Speed Sensors
4. Remove the ABS electrical connector from the wheel speed sensor (1), if equipped.
5. Remove the park brake cable from the park brake actuator.
6. Remove the mounting bolts from the rear bearing/hub.
7. Remove the wheel bearing/hub and park brake assembly from the knuckle.
8. Remove the park brake actuator from the rear wheel bearing/hub.
Installation Procedure
1. Install the park brake actuator to the rear wheel bearing/hub.
2. Install the wheel bearing/hub and park brake assembly to the knuckle.
