Impala V8-350 5.7L VIN L 4-bbl (1982)
Figure 3 - ASPIRATOR HOSE TO CHECK VALVE
3.
Install new servo (P/N 25031843) in existing servo bracket with existing screws.
4.
Cut vacuum hose from manifold to transducer 12 inches back from transducer. Insert check valve (P/N 14047619), 3 inches of 1/4 inch ID hose
not included, and check valve (P/N 10023289) as shown in view A on Figure 3.
5.
Insert other outlet of dual outlet side of P/N 10023289 into cut hose running to transducer. See Figure 3.
6.
Add approximately 4 feet of 1/4 ID hose (not included) from aspirator (P/N 25031503) to single outlet side of P/N 10023289. See Figure 3.
7.
Route above hose per drawing and band with straps (P/N 11501907) as shown.