Impala V8-5.3L (2008)
Hood Hinge: Service and Repair
Hood Hinge Replacement
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Remove the hood.
2. Remove the rear hood side seal.
3. Remove the hood assist rod.
4. Loosen the hood hinge to fender bolts, but do not remove the bolts.
5. Center punch the spot weld
6. Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
7. Remove the hood hinge to fender bolts.
8. Remove the hood hinge from the fender.
9. Repair the paint on the fender where the hood hinge was removed.
Installation Procedure
Important: Weld on body side is an assembly plant assembly aid only. Weld is not required when installing a replacement hinge.
