chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Cooling System - MIL ON DTC P0480/P0481 Set|Page 5047 > < Cooling System - MIL ON DTC P0480/P0481 Set|Page 5045
Page 3
background image

6. Remove the battery hold down bolt and the hold down. 

Note
Do not tip the battery more than 40 degrees during removal. 

7. Remove the battery. 
8. Release the inner RH headlamp retainer by pulling the retainer upward. 
9. Remove the RH headlamp assembly bolt. 

10. Pull the headlamp from the outboard edge in order to release the lock pin from the fender flange retainer. 
11. Disconnect the electrical connector before removing the headlamp from the vehicle. 

12. Remove the fuse block underhood electrical center cover (1). 

Note
Observe the positions and orientations of the forward lamp battery supply harness terminal and the fusible links on the studs before removing. 

13. At the top of the fuse block disconnect the two fasteners on the fuse block battery studs and remove the forward lamp battery supply harness

terminal and the fusible links. Remove the fasteners (1) securing the electrical center board (2). 

14. Unlock the tabs on the electrical center board, then evenly lift up on the board in order to remove it. 

Cooling System - MIL ON DTC P0480/P0481 Set|Page 5047 > < Cooling System - MIL ON DTC P0480/P0481 Set|Page 5045