Impala V8-5.3L VIN C (2006)
1. Position the inboard edge of the cooling fan relay bracket (3) that was supplied with the revised harness assembly, 22 mm (0.86 in) from the
outboard edge of the RH engine mount strut and tightly against the back edge of the radiator support.
Note
Align/adjust the ends of the bracket (3) over the radiator (2) slightly if necessary so that the holes in the bracket DO NOT sit over any spot
welds (1).
2. Mark the location of the holes in the bracket on the upper radiator support. Drill the holes using a 5 mm (3/16 in) drill bit.
20. Secure the bracket and relay assembly to the radiator core support using the rivets that were supplied.
21. Remove the screw from the top of the windshield washer solvent container filler neck at the RF fender flange in order to provide additional
clearance for routing the revised harness.
22. Route the revised harness (1) out from the engine compartment through the opening.
Note
Route the maxi fuse leads one at a time through the fender flange opening.
Route the harness back into the engine compartment between the windshield washer solvent container filler neck (2) and the RF fender flange.
23. Verify the proper routing of the harness as shown.
