Impala V8-5.3L VIN C (2006)
59. Install the retainer that secures the wiring harness to the bottom of the brace (2), then install the upper diagonal brace.
Install the RH front fender upper diagonal brace bolts (1).
Tighten
Tighten the bolts to 10 Nm (89 lb in).
60. Connect the electrical connector to the headlamp.
1. While installing the headlamp, guide the lock pin into the RH fender flange lock pin retainer.
2. Install the headlamp bolt.
Tighten
Tighten the bolt to 2Nm (18 lb in).
3. Secure the inner headlamp retainer.
61. Use the scan tool to clear any existing DTCs.
62. Use the scan tool output controls to command the Fan Relay 1, Fan Relay 2 & 3, and Fan Relays 1, 2 & 3 ON and OFF. Visually inspect both of
the cooling fans for the correct ON/OFF actions when activated. Refer to Engine Control Module Scan Tool Output Controls in SI.
