Impala V8-5.3L VIN C (2006)
7. Remove the heater pipe bracket bolt from the engine mount.
8. If necessary, remove the engine mount strut bracket bolts (engine side).
9. If necessary, remove the engine mount strut bracket (engine side).
Installation Procedure
1. If necessary, position the engine mount strut bracket (engine side) to the cylinder head.
Notice: Refer to Fastener Notice.
2. If necessary, install the engine mount strut bracket bolts (engine side).
Tighten the bolts to 48 Nm (35 ft. lbs.).
3. Install the heater pipe bracket bolt.
Tighten the bolt to 16 Nm (12 ft. lbs.).