Impala V8-5.3L VIN C (2006)
Tighten the clamps until the torque cap breaks off of the clamp.
8.
Clean the fluid from the underbody of the vehicle.
9.
Lower the vehicle.
10.
Check the power steering fluid. Add power steering fluid and bleed the system. Refer to Checking and Adding Power Steering fluid in SI.
11.
Check the power steering fluid level and bleed the system. Refer to Power Steering System bleeding in SI.
V8 Engine
Important:
The location of the leak (1) is shown above. Fittings on the hose are crimped socket and are not likely to leak.
1.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in SI.
2.
Place a drain pan under the vehicle.
3.
Remove the power steering cover pipe/hose from the retaining clips on the frame.
4.
Disconnect both stabilizer shaft links.
