Impala V8-5.3L VIN C (2006)
2. Install the positive and negative battery cable to the vehicle.
3. Raise and support the vehicle.
4. Install the positive battery cable (2) to the starter motor.
5. Install the starter solenoid BAT terminal nut (3) to the starter.
NOTE: Refer to Fastener Notice.
Tighten the nut to 10 N.m (89 lb in).
6. Position the positive battery cable boot (4) at the starter solenoid.
7. Install the positive battery cable clip (5) to the transmission stud.
8. Install the battery cable ground (7) to the transaxle stud.
9. Install the transaxle stud nut (8).
Tighten the nut to 30 N.m (22 lb ft).
10. Install the battery cable harness retainers from the engine cradle.
11. Lower the vehicle.
