Impala V8-5.3L VIN C (2006)
Alternator: Service and Repair
Generator Bracket Replacement
GENERATOR BRACKET REPLACEMENT
REMOVAL PROCEDURE
1. Remove the generator.
2. Remove the idle pulley.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the lower tensioner bolt and rotate the tensioner to access the generator bracket bolt.
5. Lower the vehicle.
6. Remove the generator bracket bolts.
7. Remove the generator bracket from the stud.
INSTALLATION PROCEDURE
1. Install the generator bracket to the stud.
2. Install the generator bracket bolts.
NOTE: Refer to Fastener Notice.
Tighten the bolts to 50 N.m (37 lb ft).
3. Raise the vehicle.
4. Install the lower generator bracket bolt.
Tighten the bolt to 50 N.m (37 lb ft).
