chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Campaign - Power Steering Hose Leak|Page 13047 > < Campaign - Power Steering Hose Leak|Page 13045
Page 10
background image

35. Install the left side engine mount lower nuts to the frame.

Tighten
Tighten the left side engine mount lower nuts to 50 Nm (37 lb ft).

36. Connect both stabilizer shaft links to the shaft.

Tighten
Tighten the stabilizer link nuts to 60 Nm (44 lb ft).

37. Install the power steering cooler pipe/hose to the frame mounted retaining clips.
38. Install the air deflector.
39. Clean power steering fluid from the underbody of the vehicle.
40. Remove the drain pan.
41. Lower the vehicle.
42. Check the power steering fluid. Add fluid and bleed the system. Refer to Checking and Adding Power Steering Fluid procedure in SI.

Owner Letter

Owner Letter

Dear General Motors Customer:

We have learned that your 2005 or 2006 model year Pontiac Grand Prix or 2006 model year Chevrolet Impala or Monte Carlo, may have a condition in
which the power steering cooler line may leak or split. If this were to occur, you would likely notice fluid spotting under the vehicle when the vehicle is
parked and a decrease in the power steering assist. If enough fluid were lost, damage to the power steering pump could occur. 

Your satisfaction with your 2005 or 2006 model year Pontiac Grand Prix or 2006 model year Chevrolet Impala or Monte Carlo is very important to us,
so we are announcing a program to prevent this condition. 

What We Will Do: Your GM dealer will replace the power steering cooler line on your vehicle. This service will be performed for you at no charge
until February 28, 2013

Campaign - Power Steering Hose Leak|Page 13047 > < Campaign - Power Steering Hose Leak|Page 13045