Impala V8-5.3L VIN C (2006)
12. Remove the right/passenger lower center pillar trim.
13. Remove the CPA (3) from the seat belt retractor pretensioner - RF connector (2).
14. Disconnect the seat belt retractor pretensioner - RF connector (2) from the vehicle harness connector (1).
15. Remove the upper trim molding from the rear quarter pillar.
16. Remove the CPA from the roof rail module - right connector.
17. Disconnect the roof rail module - right connector from the vehicle harness connector.
18. Remove the left/driver outer trim cover from the I/P.
19. Remove the CPA from the steering wheel module coil connector (1).
20. Disconnect the steering wheel module coil connector (1) from the vehicle harness connector (3).
