chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Panel Replacement|Page 21996 > < Panel Replacement|Page 21994
Page 6
background image

4. Remove the 2 trim panel screws.
5. Remove the trim panel from the door by carefully sliding the panel upward then outward.
6. Disconnect the electrical connectors.

INSTALLATION PROCEDURE

1. Connect the electrical connectors, if necessary.
2. Align the retainers with the holes in the door.
3. Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
4. Install the trim panel screws.

NOTE:  Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the trim panel screws to 2 N.m (18 lb in).

5. Install the manual lock lever by pressing the lever until the lever is completely seated.
6. Install the window-regulator handle, if necessary.
7. Install the door handle bezel.

Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escalade EXT)

Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escalade EXT)

Removal Procedure

1. Remove the door handle bezel.
2. Remove the window-regulator handle, if equipped.
3. Remove the manual lock lever from the trim panel using a flat-bladed tool.

Panel Replacement|Page 21996 > < Panel Replacement|Page 21994