K 1500 Suburban 4WD V8-4.8L VIN V (2003)
Trunk / Liftgate Shock / Support: Service and Repair
Strut Replacement - Liftgate
Strut Replacement - Lift Gate
Removal Procedure
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the
vehicle or personal injury.
1. Open and support the liftgate.
Notice: Apply pressure only at the end of the hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod
because damage or bending will result.
2. Lift up the retainer clips on the assist rods using a small flat-bladed tool.
3. Remove the upper end of the assist rods from the ball joint.
4. Remove the lower end of the assist rods from the ball joint.
5. Remove the assist rods from the liftgate.
Installation Procedure
1. Position the assist rods to the liftgate.
2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.
3. Install the lower end of the assist rods to the ball joint. Press in to place until fully seated.
4. Remove the support from the liftgate.
5. Close the liftgate.
