K 1500 Suburban 4WD V8-4.8L VIN V (2003)
1. Install the seat cushion cover to the foam pad.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the center screw retaining the latch cover.
Tighten the screw to 2 N.m (18 lb in).
3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
4. Install the seat buckles, if removed.
5. Connect the rear heater connector, if equipped.
6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
7. Install the seat cushion plastic cover to the seat cushion frame.
8. Install the rear passenger seat risers.
9. Install the rear passenger seat to the vehicle.
Seat Cushion Frame Replace - Rear (60/40 Split - 50/50 Split)
SEAT CUSHION FRAME REPLACEMENT - REAR (60/40 SPLIT - 50/50 SPLIT)
REMOVAL PROCEDURE
1. Remove the seat cushion trim cover (8) and the pad (7).
