K 1500 Suburban 4WD V8-4.8L VIN V (2003)
15. Remove the rotor by slowly turning the rotor while pulling the rotor away from the axle.
Installation Procedure
Important: Whenever the brake rotor has been separated from the hub/axle flange, any rust or contaminants should be cleaned from the
hub/axle flange and the brake rotor mating surfaces. Failure to do this may result in excessive assembled lateral runout (LRO) of the brake
rotor, which could lead to brake
pulsation.
1. Use the J 42450-A to clean all rust and contaminants from the mating surface of the hub flange.
2. Use the J 41013 to clean all rust and contaminants from the inside diameter of the hat section of the brake rotor to prevent any foreign material
from getting between the brake rotor and the hub flange.
3. Inspect the mating surfaces of the hub/axle flange and the rotor to ensure that there are no foreign particles or debris remaining.
4. Align the rotor to its original position on the hub, if applicable.
5. Install the rotor by slowly turning the rotor while pushing the rotor towards the axle.
6. If the brake rotor was removed and installed as part of a brake system repair, measure the assembled lateral runout (LRO) of the brake rotor to
ensure optimum performance of the disc brakes. Refer to Brake Rotor Assembled Lateral Runout (LRO) Measurement .
7. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. Refer to Brake Rotor Assembled
Lateral Runout (LRO) Correction .
8. Install the brake caliper and the brake caliper mounting bracket as an assembly to the vehicle.
9. Perform the following procedure before installing the 2 brake caliper bracket mounting bolts.
9.1.
Remove all traces of the original adhesive patch.
9.2.
Clean the threads of the bolts with brake parts cleaner or the equivalent and allow to dry.
9.3.
Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolts.
Note: Refer to Fastener Notice in Cautions and Notices.
10. Install the brake caliper bracket mounting bolts.
-
Tighten the brake caliper bracket mounting bolts to 200 N.m (148 lb ft).
