K 1500 Suburban 4WD V8-4.8L VIN V (2003)
5. Disengage the grommet and the cable from the floor pan.
6. Disconnect the front cable from the intermediate cable.
7. Remove the cable from the body mount by depressing the retaining tabs.
8. Remove the cable.
Installation Procedure
1. Install the cable.
2. Snap the retainer tabs into the body mount.
3. Connect the front cable to the intermediate cable.
4. Route the cable in through the floor pan and engage the grommet.
5. Remove the safety stands.
6. Lower the vehicle.
7. Roll the carpet into place.
8. Install the park brake pedal. Refer toPark Brake Pedal Assembly Replacement .
9. Adjust the park brake system. Refer toPark Brake Adjustment .
Left Rear - W/NYS
Park Brake Cable Replacement - Left Rear (with RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.