K 1500 Suburban 4WD V8-4.8L VIN V (2003)
10. Remove the camshaft.
10.1.
Install three M8-1.25 x 100 mm (M8-1.25 x 4.0 inch) bolts to the bolt holes in the front of the camshaft.
10.2.
Using the bolts as a handle, carefully rotate and pull the camshaft out of the engine block.
10.3.
Remove the three bolts from the camshaft.
11. If required, clean and inspect the camshaft and bearings.
Installation Procedure
Important: If camshaft replacement is required, the valve lifters must also be replaced.
1. Lubricate the camshaft journals and the bearings with clean engine oil.
2. Install three M8-1.25 x 100 mm (M8-1.25 x 4.0 inch) bolts to the bolt holes in the front of the camshaft.
Notice:
All camshaft journals are the same diameter, so care must be used in removing or installing the camshaft to avoid damage to the camshaft
bearings.
3. Using the bolts as a handle carefully install the camshaft into the engine block.
4. Remove the three bolts from the front of the camshaft.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
Important: Install the retainer plate with the sealing gasket facing the engine block
The gasket surface on the engine block should be clean and free of dirt and/or debris.
