K 1500 Suburban 4WD V8-4.8L VIN V (2003)
2. Install the power steering gear inlet hose (3) to the power steering pump (1).
3. Install the power steering gear inlet hose to the power steering gear.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the power steering gear inlet hose fittings to 28 N.m (20 lb ft).
4. Remove the drain pan from under the vehicle.
5. Install the engine protection shield.
6. Lower the vehicle.
7. Bleed the power steering system. Refer to Bleeding the Power Steering System.
