K 1500 Suburban 4WD V8-4.8L VIN V (2003)
1. Install the generator cable (2) to the junction block.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the generator cable nut.
Tighten
Tighten the nut to 9 N.m (80 lb in).
3. Close the positive cable junction block.
4. Install the generator cable to the generator, perform the following:
4.1.
Install the generator cable to the stud.
4.2.
Install the generator cable nut.
Tighten
Tighten the nut to 9 N.m (80 lb in).
4.3.
Position the boot to cover the stud.
5. If necessary, install the engine sight shield.
6. Connect the negative battery cable.