K 1500 Suburban 4WD V8-4.8L VIN V (2003)
4. Install the J 29193.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Tighten the steering linkage installer in order to seat the ball stud in the relay rod.
Tighten
Tighten the installer to 54 N.m (40 lb ft).
6. Remove the J 29193.
7. Install the prevailing torque nuts.
Tighten
-
Tighten the mounting nut to 40 N.m (30 lb ft).
-
Tighten the ball stud nut to 40 N.m (30 lb ft).
8. Install the engine protection shield, if equipped.
9. Lower the vehicle.
