K 1500 Suburban 4WD V8-4.8L VIN V (2003)
2. Ensure that the jackscrew for J 43911is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
3. Rotate the J 43911 so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool is
firmly attached to the seal shell.
4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure
1. Carefully slide a new selector shaft seal (1) over the selector shaft (2) with the wide face of the steel case facing outward. Position the seal so that
it is starting to enter the seal bore.
2. Using J 43909, remove the inner sleeve so that the tool will slide over the selector shaft
3. Slide the J 43909 into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909 and drive the new seal
into the seal bore until it is seated at the bottom of the bore.
4. Install the PNP switch.
5. Fill the transmission to the proper level with DEXRON III in transmission fluid.
Transmission Extension Housing Rear Oil Seal
4L80-E/4L85-E
Transmission Extension Housing Rear Oil Seal Replacement
*
Tools Required
-
J 41505 Output Shaft Seal Installer
-
J 6125-1B Slide Hammer
-
J 23129 Universal Seal Remove
-
J 36850 Transjel
Removal Procedure
1. Place a drain pan under the vehicle.
2. Remove the propeller shaft.
