K 1500 Suburban 4WD V8-4.8L VIN V (2003)
10. Install the propeller shaft (3) to the pinion yoke (4).
Align the reference marks made during removal.
11. Install the propeller shaft yoke retaining clamps and the bolts,
Tighten the propeller shaft yoke retaining clamp bolts to 25 Nm (18 ft. lbs.).
12. Install the axle shafts.
13. Install the brake rotors.
14. Install the brake calipers.
15. Install the tire and the wheel.
16. Inspect and add axle lubricant to the axle housing, if necessary.
17. Lower the vehicle.
Drive Pinion Housing and/or Seal Replacement
Drive Pinion Housing and/or Seal Replacement
Tools Required
^
J44414 Pinion Seal Installer
^
J22912-01 Bearing Split-Plate Puller
^
J24433 Pinion Cone and Side Bearing Installer
^
J37624 Pinion Bearing Installer
^
J8092 Driver Handle
^
J8608 Rear Pinion Bearing Race Installer
^
J8614-01 Flange/Pulley Holding Tool
Removal Procedure
Important: Observe and mark the positions of all the driveline components, relative to the propeller shaft and the axles, prior to disassembly. These
components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. Reassemble all the components in the exact places in which you
removed the parts. Follow any specifications, torque values, and any measurements made prior to disassembly.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Drain the axle lubricant.
3. Remove the axle shafts.
