K 1500 Suburban 4WD V8-4.8L VIN V (2003)
23. Measure the rotating torque of the pinion and the ring gear. Compare this measurement with the rotating torque recorded during removal.
Specification
The rotating torque of the pinion and the ring gear should be between 3.9 - 6.2 Nm (30 - 55 inch lbs.) for new bearings or 2.8 - 5.6 Nm (25 - 50
inch lbs.) for used bearings.
24. If the rotating torque of the pinion and the ring gear is not within specifications, adjust the preload of the pinion or the differential side bearings as
necessary.
25. Install the propeller shaft (3) to the pinion yoke (4).
Align the reference marks made during removal.
26. Install the propeller shaft yoke retaining clamps and the bolts.
Tighten the propeller shaft yoke retaining clamp bolts to 25 Nm (18 ft. lbs.).
27. Install the axle shafts.
28. Fill the axle with axle lubricant.
29. Lower the vehicle.
