K 1500 Suburban 4WD V8-4.8L VIN V (2003)
7. If equipped with the single clamp style boot, remove the propeller shaft from the transfer case output shaft by sliding the propeller shaft forward.
8. If equipped with the double clamp style boot, perform these steps to remove the propeller shaft from the transfer case.
8.1.
Remove the boot from the groove on the OD of the output shaft.
8.2.
Remove the propeller shaft from the transfer case output shaft by sliding the propeller shaft forward.
Installation Procedure
1. Inspect the splines of the transfer case output shaft for a sufficient coating of grease. If the output shaft does not have a sufficient coating of grease,
lubricate the shaft with grease, GM P/N 12345879 or equivalent.
2. If equipped with the double clamp style boot, perform these steps to install the propeller shaft to the transfer case.
2.1.
Place a new clamp in the groove of the propeller shaft boot.
2.2.
Install the propeller shaft splines in the transfer case output shaft.
2.3.
Install the boot onto the transfer case output shaft until the boot snaps into the groove on the OD of the output shaft.
3. If equipped with the single clamp style boot, install the propeller shaft splines into the transfer case output shaft.
