K 1500 Suburban 4WD V8-4.8L VIN V (2003)
6. Install the tripot spider assembly (3) onto the halfshaft bar (2).
7. Install the spacer ring (1) in the groove at the end of the halfshaft bar (2).
8. Pack the tripot seal (4) and the tripot housing (1) with the grease supplied in the kit. The amount of grease supplied in this kit has been
pre-measured for this application.
9. Reassemble the tripot housing and the tripot seal using this procedure:
9.1.
Pinch the swage ring (2) slightly by hand in order to distort it into an oval shape.
9.2.
Slide the distorted swage ring (2) over the large diameter of the seal.
9.3.
Place the tripot housing over the spider assembly.
9.4.
Install the seal onto the tripot housing.
9.5.
Align the tripot seal (1), with the swage ring (2) in place, over the flat area on the tripot housing (3).
