K 1500 Suburban 4WD V8-4.8L VIN V (2003)
8. Insert a flat-tipped screwdriver or small pry bar into the space between the lip of the outer race of the seal and the transfer case.
9. Remove the remaining part of the output shaft seal from the transfer case.
Installation Procedure
1. Install the J43484 (2) to the J8092 (1).
2. Install a NEW seal onto J43484.
3. Using J43484 (2), and J8092 (1), install the seal.
4. Install the front propeller shaft.
5. Check the fluid level. Add fluid, if necessary.
6. Install the transfer case shield, if equipped.
7. Lower the vehicle.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
Tools Required
^
J45756 Output Shaft Seal Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield, if equipped.
3. Remove the rear propeller shaft.
