K 1500 Suburban 4WD V8-5.3L VIN T (2002)
3. Install the brake caliper.
4. Install the tire and wheel assembly.
5. Remove the safety stands.
6. Lower the vehicle.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
10. Fill the master cylinder reservoir to the proper level with clean brake fluid.
11. Burnish the brake pads and rotors.
