K 1500 Suburban 4WD V8-5.3L VIN T (2002)
![background image](/chevrolet/k_1500_suburban_4wd/v8-5.3l_vin_t/Page-3563012.png)
1. Separate the connector halves (1).
2. Open the secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector (1).
3. Grasp the wire and push the terminal to the forward most position. Hold the wire in this position.
4. Insert the Weather Pack(R) terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder (1).
5. Gently pull on the wire to remove the terminal through the back of the connector (2).
IMPORTANT: Never use force to remove a terminal from a connector.
6. Inspect the terminal and connector for damage. Repair as necessary. Refer to Repairing Connector Terminals. See: General Electrical Diagnostic
Procedures/Wiring Repairs/Connector Repairs/Repairing Connector Terminals
7. Reform the lock tang (2) and reset terminal in connector body.
8. Close secondary locks and join connector halves.
9. Verify that circuit is complete and working satisfactorily.
10. Perform system check.
General Information
The Wiring Repairs contains the following types of wiring repair information. Using these elements together will make wiring repair faster and easier:
-
Circuit Protection - Fuses
-
Circuit Protection - Circuit Breakers
-
Circuit Protection - Fusible Links
-
Repairing Damaged Wire Insulation
-
Splicing Copper Wire Using Splice Clips
-
Splicing Copper Wire Using Splice Sleeves
-
Splicing Twisted or Shielded Cable
-
Splicing Inline Harness Diodes
-
Heated Oxygen Sensor (HO2S) Wiring Repairs