K 1500 Suburban 4WD V8-5.3L VIN T (2002)
Ride Height Sensor: Service and Repair
Front Position Sensor Replacement - Electronic Suspension
Front Position Sensor Replacement - Electronic Suspension
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the sensor harness connector from the vehicle harness connector.
3. Remove the wheel speed sensor wire from the Real Time Damping (RTD) sensor bracket.
4. Remove the wheel speed sensor wire from the (RTD) sensor bracket.
5. Remove the (RTD) sensor link bracket bolt from the upper control arm.
6. Remove the bolt from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.