K 1500 Suburban 4WD V8-5.3L VIN T (2002)
1. Install the J 43484 (2) to the J 8092 (1).
2. Install the transfer case front input shaft on the J 43484.
3. Using the J 43484 (2) and the J 8092 (1), install the transfer case output seal.
4. Install the front propeller shaft.
5. Check the transfer case fluid level.
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement- Rear
Transfer Case Output Shaft Seal Replacement- Rear
^
Tools Required
-
J 37668-A Seal Installer
-
J 45380 Transfer Case Rear Bushing Remover and Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield, if equipped.
3. Remove the rear propeller shaft.
4. Remove the rear output shaft seal.