K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
Pedal Positioning Sensor: Service and Repair
BRAKE PEDAL POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the brake pedal position sensor electrical connector.
2. Remove the brake pedal position sensor bolt.
3. Remove the brake pedal position sensor from the vehicle.
INSTALLATION PROCEDURE
1. Install the brake pedal position sensor to the vehicle.
2. Install the brake pedal position sensor bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
3. Connect the brake pedal position sensor electrical connector.
