K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).
3. Slide the module (2) to the left to engage the lower retainers.
4. Install the module retaining screws (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 3 N.m (26 lb in).
5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, the seat needs to synchronized:
7.1. Operate the seat in all directions:
-
Front tilt
-
Rear tilt
-
Horizontal
-
Recline
7.2.
If the seat stops part way due to programmed soft stop, release the switch and operate again in the same direction till the seat touches the
mechanical stop.
7.3.
Repeat the above for all seat positions.
