K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
5. Install the brake hose into the brake hose bracket.
6. Install the brake hose retaining clip (3).
7. Remove the rubber cap or plug from the brake pipe fitting end.
8. Connect the brake pipe fitting end (1) to the brake hose (2):
-
Use a backup wrench on the brake hose fitting end (2).
-
Do not bend the mounting bracket or the brake pipe.
-
Tighten the brake pipe fitting end (1) to 25 N.m (18 lb ft).
9. Bleed the hydraulic brake system. Refer to in Hydraulic Brake System Bleeding (Manual)Hydraulic Brake System Bleeding (Pressure) .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Important: Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. Inspect the brake hose
in extreme right and left turn conditions. If the brake hose makes contact remove the brake hose and correct the condition.
11. Lower the vehicle.
Rear Caliper
Brake Hose Replacement - Rear (Caliper)
Removal Procedure
Caution: Refer to Brake Fluid Irritant Caution in Cautions and Notices.
Note: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Clean all dirt and foreign material from the brake hose end and brake pipe fitting.
Important: Install a rubber cap or plug to the exposed brake pipe fitting end in order to prevent brake fluid loss and contamination.
4. Use a backup wrench on the brake hose fitting end (1), disconnect the brake pipe fitting end (2) from the brake hose (1) then cap or plug the brake
