K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
Parking Brake Pedal: Service and Repair
Park Brake Pedal Assembly Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
3. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
4. Remove the safety stands.
5. Lower the vehicle.
6. Remove the left side hinge pillar panel. Refer to Trim Panel Replacement - Hinge Pillar in Interior Trim.
7. Disconnect the park brake warning lamp connection.
8. Remove the MID-Bussed Electrical Center from the bracket.
9. Disconnect the park brake release cable from the park brake lever.
