K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
Ride Height Sensor: Service and Repair
Rear Position Sensor Link ASSY Replace - Electronic Suspension
REAR POSITION SENSOR LINK ASSEMBLY REPLACEMENT - ELECTRONIC SUSPENSION
TOOLS REQUIRED
J 38185 Spring Hose Clamp Pliers
REMOVAL PROCEDURE
1. Remove the ESC sensor from the vehicle.
IMPORTANT: Do not attempt to pry the link rod from the electronic suspension control (ESC) ball stud. If the link rod needs to be replaced or
disconnected, you must use the following procedure.
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the frame bracket ball stud.
INSTALLATION PROCEDURE
1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the frame bracket.
2. Install the ESC sensor to the vehicle.
