K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
Carrier Bearings: Service and Repair
Differential Side Bearings Replacement (9.75 Inch Axle)
Tools Required
^
J22888-D Side Bearing Remover Kit
^
J24430 Differential Side Bearing Installer
^
J36597 Side Bearing Puller Pilot - 9.25 inch
^
J45711 Differential Side Bearing Remover - Dana 248
^
J45900 Differential Side Bearing Installer - Dana Axles
^
J8092 Universal Driver Handle - 3/4 inch - 10
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the differential assembly.
3. Remove the differential side bearing as follows:
3.1.
Install the J45711 (2) and the J36597 (1) as shown.
3.2.
Remove the differential side bearing using the J45711 and a hydraulic press.
Important: Mark the inboard shims left or right.
4. Remove the inboard shims.
Installation Procedure
1. Determine the shim thickness and preload for the differential assembly.
2. Install the differential side bearing as follows:
2.1.
In order to protect the differential case, install the J8107-3 in the case on the side opposite of the bearing installation.
2.2.
Install the inboard shims.
2.3.
Install the differential side bearing.
2.4.
Install the J24430 or the J45900 (2) and the J8092 (1) over the differential side bearing.
2.5.
Drive the differential side bearing into position using the J24430 or the J45900 and the J8092.
