K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
5. Rotate J41187 toward the clip in order to bend the band onto the clip.
6. Pull on the tool's cutting handle in order to cut off the excess band.
7. Pound the band flat between the latch tabs. Peen the latch tabs over in order to lock the band into position.
8. Twist the halfshaft seal cover (1):
^
K15 = 180 degrees
^
K25/35 = 90 degrees
Important: Be sure that the inboard tab of the halfshaft seal cover (1) is 180 degrees opposite the outboard tab of the halfshaft seal cover (1) before
proceeding.
9. Position the outboard end of the halfshaft seal cover (1) over the CV joint (2) flat.
Important: Tighten the seal cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the
