K 1500 Suburban 4WD V8-5.3L VIN Z Flex Fuel (2003)
4. Remove the rear output shaft seal by prying it out with a flat tipped screwdriver.
Installation Procedure
1. Using J45756, install a NEW front output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid, if necessary.
4. Install the transfer case shield, if equipped.
5. Lower the vehicle.
Transfer Case Input Shaft Seal Replacement
Transfer Case Input Shaft Seal Replacement
Tools Required
^
J36825 Output Shaft Oil Seal Remover
^
J23907 Slide Hammer with Bearing Adapter
^
J42738 Front Output Shaft Seal Installer
Removal Procedure
1. Remove the transfer case.
Important: It may be necessary to use a sharp punch in order to poke a hole into the seal prior to inserting J36825.
