K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
Tool Required:
J 38778 Trim Panel Remover
1. Disconnect the negative battery cable.
2. Remove the door handle bezel.
3. Remove the window regulator handle, as necessary.
4. Disconnect the power accessory switch mounting panel wiring connector, as necessary.
5. Remove the trim panel upper extension.
6. Using a flat blade tool, carefully pry off the trim panel armrest screw cover in order to access the screw.
7. Remove the trim panel armrest screw.
8. Using the J 38778, carefully pry the retainer from the retainer seats.
9. Disconnect the courtesy light connector, if necessary.
10. Remove the trim panel from the door.
11. Remove the courtesy lamp lens or the reflector.
12. Pull the retainers from the slot in the trim panel.
13. Remove the retainers.
Installation Procedure
1. Push the retainer from the slot.
2. Install the retainers to the trim panel.
3. Install the courtesy lamp lens or the reflector.
4. Align the retainers with the holes in the door.
5. Install the trim panel to the door by carefully applying pressure in order to seat the retainers.
6. Install the window regulator handle, as necessary.
7. Install the power accessory switch mounting panel, as necessary.
8. Install the trim panel armrest screw.
Tighten
