K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
7. Install the three BPMV to bracket retaining bolts (8).
^
Tighten the three bolts to 9 Nm (7 ft. lbs.).
8. Connect the four electrical connectors to the EBCM (2).
9. Install the EHCU to the vehicle frame.
^
Tighten the three bolts to 12 Nm (9 ft. lbs.).
10. Install the right front, left front and rear brake pipes to the tube adapters (5).
^
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
11. Install the front and rear brake pipes (from master cylinder) to the combination valve (111).
^
Tighten the three brake pipe fittings to 30 Nm (22 ft. lbs.).
12. Connect the electrical connector (9) to the combination valve (11).
13. Connect the negative battery cable.
IMPORTANT: Verify that the combination valve metering rod is depressed during bleeding.
14. Bleed the brake system. See: Brake Bleeding
15. Return to A Diagnostic System Check - ABS See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
