K 1500 Suburban 4WD V8-6.5L DSL Turbo VIN F (1999)
10. Immerse the opposite end of the hose into a container partially filled with clean brake fluid.
11. Slowly open the bleeder valve at least 3/4 of a turn. Allow the fluid to flow until you see no air in the fluid.
NOTICE: Refer to Fastener Notice in Service Precautions.
12. Tighten the wheel cylinder or caliper bleeder valve.
^
Tighten the wheel cylinder or caliper bleeder valve to 13 Nm (110 inch lbs.).
13. Check the brake pedal for sponginess. Repeat the bleeding procedure if the brake pedal is spongy.
14. Repeat steps 9 - 12 at every wheel.
15. Disconnect the hose from the bleeder adapter.
16. Remove the J 29567 Brake Bleeder Adapter.
17. Fill the master cylinder to the proper level.
